[SMS]

[gerasimos_h]

*.tgz ,*.tar and *tar.gz are tarballs they are the same, slackware use the *.tgz extension because packages were tarballs.
So you install the source of qiv as package, you probably filled up your root directory or your existing `pwd` with garbage.

You need to build qiv, or if you found it elsewhere (slacky.eu) for slackware 13.0 you can try to install it to see if it's working, and if not uninstall it and build it from source.
Don't forget to install the dependencies for those packages too.

I'll take a look later today.

gerasimos_h

[vivanguarda]

I uninstalled qiv ( removepkg qiv-2.2.3.tgz )! But, I think tarball was a tar.gz, tar.bz, tar.bz2... A arquive in its source-code! And tgz was a prepared archive using individuals compliles options, like:


a)./configure ( prefix = usr or usr/local), (sisconfdir=/usr/local/etc or /etc);
b)DESTDIR ( /tmp or /usr );
c) Strip uses or not;
d) Cflags Cpu optimization use or not...; and
e) Checkinstall uses or not

Well... Hehehe, go ahead!

I`m yet looking for qiv and its system dependencies and I very gratefully for your help!

[vivanguarda]

Sorry, douple post but this is a good notice! I nedeed libXinerama, libgnomecanvas, libpthread-stubs, renderproto, xineramaproto, xproto, kbproto and gnome-doc-util. Then Qiv and Zenity isntalled!

After that I will annoy in Htb and Squid hierarquic bandwidht control uses.

Thanks a lot!!!

[gerasimos_h]

I haven't had the time to take a look at it, but I will.

gerasimos_h

[vivanguarda]

Curiously, it seemed to be ok, but I `m trying to run Cyber Control programm and when I open a Normal X Session it`s no function. Then if I lock current and start a Root Session and go to konsole... Bingo! That`s all right. Have you already seen it? Is it important change inittab and in fact restart X after normal user creation?

This is a output error and /etc/sudoers was edited.

normal@server:/etc$ sudo -H xlanbr
mkdir: cannot create directory `/root/.dosemu': File exists
No protocol specified
ERROR: X: Can't open display ":0.0".
Either the connection was refused and you do not have enough
access rights to connect to your X server or there is
something wrong with the contents of your DISPLAY variable.
If the connection was refused then please consult your system
administator or read the X documentation for a solution
(use xauth, xhost, or ssh -X)


-------


#sudoers file.
#
# This file MUST be edited with the 'visudo' command as root.
# Failure to use 'visudo' may result in syntax or file permission errors
# that prevent sudo from running.
#
# See the sudoers man page for the details on how to write a sudoers file.
#

# Host alias specification

# User alias specification

# Cmnd alias specification

# Defaults specification

# Runas alias specification

# User privilege specification
root ALL=(ALL) ALL
normal ALL=NOPASSWD: /usr/bin/lanbr
normal ALL=NOPASSWD: /usr/bin/xlanbr

# Uncomment to allow people in group wheel to run all commands
# %wheel ALL=(ALL) ALL

[vivanguarda]